Supermicro ipmi port forwarding

The first ports you have to allow are of course TCP 80 and 443 for web management interface. Almost all IPMI implementations have it and quite often it’s the interface with the most features. For example, Supermicro’s implementation only allows BIOS update and port number changes over web interface. This interface unfortunately stops just short of allowing console access. To […]

Streaming HLS and MPEG-DASH from behind reverse proxy

There are use cases when a media streamer is putting Nimble Streamer media server behind the reverse proxy. This is usually done for security reasons and works pretty good. But there is a side effect of this solution. For each connection, Nimble Streamer gets the IP of the proxy instead of IP of the viewer. This means […]

How to enable/disable firewall on Ubuntu 18.04 Bionic Beaver Linux

Objective The objective is to show how to enable or disable firewall on Ubuntu 18.04 Bionic Beaver Linux Check a current firewall status Enable Firewall To enable firewall execute: Firewall, is now enabled: Disable Firewall UFW is quite intuitive to use. To disable firewall execute: Confirm the firewall status:

Remove Proxmox 6.0/5.1+ Subscription Notice

With the release of Proxmox 5.1 and newer (including 6.0) you’ll find the code related to the no subscription message that pops up on login has changed and prior instructions for removing it wont work. To remove “You do not have a valid subscription for this server” run the command bellow. You will need to […]

Cisco Configure Basic

#config terminal#write memory#show vlan#show ip interface [number]#show vlan id [number]#show interfaces switchport FastEthernet [number]#hostname [name]#no ip addeess#no ip address dhcp#copy running-config startup-config#show interfaces status#switchport mode access#switchport access multicast-tv vlan [number]#copy running-config startup-config https://www.cisco.com/c/en/us/support/switches/small-business-300-series-managed-switches/tsd-products-support-series-home.html

Nimble Streaming Config

sudo nano /etc/nimble/nimble.conf nano /etc/nimble/nimble.conf sudo service nimble restart start stop Config allhttps://wmspanel.com/nimble/param Config SSLhttps://blog.wmspanel.com/2019/08/using-certbot-letsencrypt-nimble-streamer.html